Name: Cisco Catalyst C3850 Series
Brand: Cisco
Rating: 5 (1 reviews)

To Next Page

To Previous Page

ActionInterface

Configure this interfaceTenGigabitEthernet1/1/1

Configure this interfaceTenGigabitEthernet1/1/2

Configure this interfaceTenGigabitEthernet1/1/3

Configure this interfaceTenGigabitEthernet1/1/4

Configure this interfaceTenGigabitEthernet1/1/5

Configure this interfaceTenGigabitEthernet1/1/6

Configure this interfaceTenGigabitEthernet1/1/7

Configure this interfaceTenGigabitEthernet1/1/8

Removing a Network Module

The switch complies with EMC, safety, and thermal specifications when a network module is present. If no

uplink ports are required, install a blank network module.

Note

To avoid authentication failure and non-detection of modules, wait for a minimum of five seconds between

the online insertion and removal (OIR) of network modules.

Note

Procedure

Step 1 Attach an ESD-preventive wrist strap to your wrist and to an earth ground surface

Do not remove the network module with connected cables or installed SFP modules. Always remove

any cables and modules before you remove the network module.

Caution

A module interface might become error-disabled when a network module with connected fiber-optic

cables is installed or removed. If an interface is error-disabled, you can reenable the interface by

using the shutdown and no shutdown interface configuration commands.

Caution

Step 2 Disconnect the cables from the SFP modules.

Step 3 Remove the SFP modules from the network module.

Step 4 Loosen the captive screws that hold the network module in place.

Catalyst 3850 Switch Hardware Installation Guide

OL-26779-0564

Installing a Network Module

Removing a Network Module

Questions and Answers:

Need help?

Do you have a question about the Cisco Catalyst C3850 Series and is the answer not in the manual?

Cisco Catalyst C3850 Series Specifications

General