Cisco Catalyst IE-9320-26S2C-A - Stacking Interface

90 pages

To Next Page

To Previous Page

Cisco Catalyst IE9300 Rugged Series Switch Hardware Installation Guide

Cisco IE9300 Rugged Series Overview

Stacking Interface

Main Page

Communications, Services, and Additional Information2
Cisco Bug Search Tool3
Documentation Feedback3
Bias Free Language3
Table of Contents5
Cisco IE9300 Rugged Series Overview9
About the Cisco Catalyst IE9300 Rugged Series Switch9
Switch Models9
Front Panel11
Display Mode Button12
Express Setup Button12
System LED13
Power Supplies13
Gigabit Ethernet Ports15
Alarms16
Console Ports17
SD Card Connector18
USB Host Port19
Stacking Interface19
Switch Installation21
Preparing for Installation21
Warnings21
Installation Guidelines23
Required Tools and Equipment23
Verifying the Package Contents23
Verifying the Switch Operation23
Switch Installation24
Rack-Mount Installation24
Attach Brackets for 19-Inch Racks25
Attach Brackets for 19-Inch Racks for IP-30 Compliance (Optional)26
Attach Brackets for 23-Inch Racks28
Attach Brackets for ETSI Racks29
Rack-Mount the Switch30
Installing Multiple Switches in the Rack32
Wall-Mount Installation33
Attach Wall-Mount Brackets35
Wall-Mount the Switch36
SFP Installation37
SFP Installation Considerations and Guidelines38
Install Fiber Optic SFP Modules39
Install 100/1000BASE-T SFP Modules39
Guidance for Connecting to SFP Modules41
Connect to a Fiber Optic SFP Module41
Connect to a 1000BASE-T SFP Module42
Remove SFP Modules42
Replace the SD Flash Memory Card43
Connecting Devices to the Ethernet Ports43
Power Supply Installation45
Power Supply Modules45
Power Supply Installation Guidelines46
Installing a Power-Supply Module47
Required Tools and Equipment47
Ground the Switch48
Install the Power-Supply Module in the Switch50
Wire the Power Source51
Remove the Power-Supply Module54
Express Setup57
Required Equipment57
Run Express Setup58
Switch Configuration with the CLI Setup Program63
Configuring the Switch with the CLI-Based Setup Program63
Accessing the CLI through the Console Port63
RJ-45 Console Port63
USB Micro-Type B Console Port64
Entering the Initial Configuration Information65
IP Settings65
Complete the Setup Program65
Troubleshooting71
Diagnosing Problems71
Switch Boot Fast71
Switch Leds71
Switch Connections72
Bad or Damaged Cable72
Ethernet and Fiber-Optic Cables72
Link Status72
10/100/1000 Port Connections73
SFP Module73
Interface Settings73
Ping End Device73
Spanning Tree Loops73
Switch Performance74
Speed, Duplex, and Autonegotiation74
Autonegotiation and Network Interface Cards74
Cabling Distance74
Reset the Switch74
Recovering Passwords75
Finding the Switch Serial Number75
Cables and Connectors77
Connector Specifications77
10/100/1000 Ports77
SFP Module Connectors77
Console Port78
Alarm Port79
Cables and Adapters79
SFP Module Cables79
Console Port Adapter Pinouts80
Hazardous Location Installation Information81
Hazardous Area Installation Warnings81
North American Hazardous Location Approval83
EMC Environmental Conditions for Products Installed in the European Union84
Hazardous Locations Standards84
Technical Specifications87
Switch Specifications87
Power-Supply Module Specifications89
Alarm Ratings89

Cisco Catalyst IE-9320-26S2C-A - Stacking Interface

Table of Contents

Related product manuals