CHAPTER 4
Express Setup
• Express Setup, on page 49
• Required Equipment, on page 49
• Run Express Setup, on page 50
Express Setup
When you first set up the switch, you should use Express Setup to enter the initial IP information. This process
enables the switch to connect to local routers and the Internet. You can then access the switch through the IP
address for additional configuration.
Required Equipment
You need this equipment to set up the switch:
• Computer running Windows or a Mac.
• A web browser with JavaScript enabled.
Google Chrome 38 or later, Mozilla Firefox 35 or later, or Apple Safari 7 or later.
• A straight-through Category 5 Ethernet cable to connect your computer to the switch port.
Do not use the RS-232 serial console port for Express Setup.
Note
• A small paper clip to reach the button.
Before running Express Setup, disable any pop-up blockers or proxy settings on your browser and any
wireless client running on your computer.
Note
Cisco Catalyst IE9300 Rugged Series Switch Hardware Installation Guide
49
To Next Page
Loading...
Need help?
General