Index
IN-5
Cisco 850 Series and Cisco 870 Series Access Routers Software Configuration Guide
OL-5332-01
configuring 3
interface configuration mode 3
interface port labels (table) 1
interleaving, PPP 9
Internet connection, setting up 4
IP, overview 2
IPCP 8
IP Precedence
with CBWFQ 10
overview 9
IP routing, setting up 4
IPSec tunnel
configuration example 11, 9
configuring 1
crypto method 8, 6
transforms and protocols 7, 5
ISDN
configuring the BRI 17
configuring the peer router 20
S/T port for dial backup 16
ISDN interface, configuring 17
ISDN peer router, configuring 20
K
k command 9
L
LAN with DHCP and VLANs, configuring 1 to 8
LCP 4
LFQ 10
line configuration mode 4
Link Control Protocol
See LCP
LLC 6
loopback interface, configuring 8 to 9
low latency queuing
See LFQ
M
meminfo command 9
metrics
EIGRP 3
RIP 3
mode configuration, applying to crypto map 6
modes
See command modes
N
NAT
configuration example 8, 11
configuring with PPPoA 9
configuring with PPPoE 1, 6
overview 7 to 8
See also Easy IP (Phase 1)
NCP 4
network address translation
See NAT
network configuration, preparing for 4
Network Control Protocols
See NCP
network protocols 2
network scenarios
See configuration examples
nonvolatile RAM
See NVRAM
note, described 13
NVRAM, saving changes to 7
O
overloading, defined 8
To Next Page
Loading...
