Cisco CISCO851-K9 - 851 Integrated Services Router User Manual

13-3
Cisco 850 Series and Cisco 870 Series Access Routers Software Configuration Guide
OL-5332-01
Chapter 13 Configuring Dial Backup and Remote Management
Dial Backup Feature Activation Methods
Note When static routes are configured, the primary interface protocol must go down in order to activate the
floating static route.
Configuring Floating Static Routes
Static and dynamic routes are the two components of floating static routes. Perform these steps to
configure the static and dynamic routes on your router, beginning in global configuration mode:
Command Purpose
Step 1
ip route prefix mask {ip-address | interface-type
interface-number [ip-address]}
Example:
Router(config)# ip route 0.0.0.0 0.0.0.0
22.0.0.2
Router(config)#
Assigns the primary static route.
Step 2
ip route prefix mask {ip-address | interface-type
interface-number [ip-address]} [distance]
Example:
Router(config)# ip route 0.0.0.0 0.0.0.0
192.168.2.2 150
Router(config)#
Assigns the lower routing administrative distance
value for the backup interface route. 192.168.2.2
is the peer IP address of the backup interface.
Step 3
router rip
Example:
Router(config)# router rip
Router(config)#
Enables RIP routing.
Step 4
network ip-address
Example:
Router(config)# network 22.0.0.0
Router(config)#
Defines the primary interface network. 22.0.0.0 is
the network value of the primary interface.
Step 5
ip route prefix mask {ip-address | interface-type
interface-number [ip-address]} [distance]
Example:
Router(config)# ip route 0.0.0.0 0.0.0.0
192.168.2.2 150
Router(config)#
Assigns the lower routing administrative distance
value for the backup interface route. 192.168.2.2
is the peer IP address of the backup interface.

Cisco CISCO851-K9 - 851 Integrated Services Router Specifications

General

Brand	Cisco
Model	CISCO851-K9 - 851 Integrated Services Router
Category	Network Router
Language	English