Cisco CISCO851-K9 - 851 Integrated Services Router User Manual

1-7
Cisco 850 Series and Cisco 870 Series Access Routers Software Configuration Guide
OL-5332-01
Chapter 1 Basic Router Configuration
Configuring Basic Parameters
Configure the ATM WAN Interface
This procedure applies only to the Cisco 857, Cisco 876, Cisco 877 and Cisco 878 models.
Perform these steps to configure the ATM interface, beginning in global configuration mode:
Command Purpose
Step 1
For the Cisco 878 model only:
controller dsl 0
mode atm
exit
Example:
Router(config)# controller dsl 0
Router(config-controller)# mode atm
Router(config-controller)# exit
Router(config)#
For routers using the G.SHDSL signaling, perform
these commands. Ignore this step for routers using
ADSL signaling.
Step 2
interface type number
Example:
Router(config)# interface atm0
Router(config-int)#
Identifies and enters the configuration mode for an
ATM interface.
Step 3
ip address ip-address mask
Example:
Router(config-int)# ip address 10.10.10.100
255.255.255.0
Router(config-int)#
Sets the IP address and subnet mask for the ATM
interface.
Step 4
no shutdown
Example:
Router(config-int)# no shutdown
Router(config-int)#
Enables the ATM 0 interface.
Step 5
exit
Example:
Router(config-int)# exit
Router(config)#
Exits configuration mode for the ATM interface
and returns to global configuration mode.
Configure the Wireless Interface
The wireless interface enables connection to the router through a wireless LAN connection. For more
information about configuring a wireless connection, see
Chapter 9, “Configuring a Wireless LAN
Connection,” and the Cisco Access Router Wireless Configuration Guide.

Cisco CISCO851-K9 - 851 Integrated Services Router Specifications

General

Brand	Cisco
Model	CISCO851-K9 - 851 Integrated Services Router
Category	Network Router
Language	English