6-5
Cisco 850 Series and Cisco 870 Series Access Routers Software Configuration Guide
OL-5332-01
Chapter 6 Configuring a VPN Using Easy VPN and an IPSec Tunnel
Configure Group Policy Information
Configure Group Policy Information
Perform these steps to configure the group policy, beginning in global configuration mode:
Command or Action Purpose
Step 1
crypto isakmp client configuration group
{group-name | default}
Example:
Router(config)# crypto isakmp client
configuration group rtr-remote
Router(config-isakmp-group)#
Creates an IKE policy group containing attributes
to be downloaded to the remote client.
Also enters the Internet Security Association Key
and Management Protocol (ISAKMP) group
policy configuration mode.
Step 2
key name
Example:
Router(config-isakmp-group)# key
secret-password
Router(config-isakmp-group)#
Specifies the IKE pre-shared key for the group
policy.
Step 3
dns primary-server
Example:
Router(config-isakmp-group)# dns 10.50.10.1
Router(config-isakmp-group)#
Specifies the primary Domain Name System
(DNS) server for the group.
Note You may also want to specify Windows
Internet Naming Service (WINS) servers
for the group by using the wins command.
Step 4
domain name
Example:
Router(config-isakmp-group)# domain
company.com
Router(config-isakmp-group)#
Specifies group domain membership.
Step 5
exit
Example:
Router(config-isakmp-group)# exit
Router(config)#
Exits IKE group policy configuration mode, and
enters global configuration mode.
Step 6
ip local pool {default | poolname}
[low-ip-address [high-ip-address]]
Example:
Router(config)# ip local pool dynpool
30.30.30.20 30.30.30.30
Router(config)#
Specifies a local address pool for the group.
For details about this command and additional
parameters that can be set, see the
Cisco IOS Dial
Technologies Command Reference.
To Next Page
Loading...
Need help?
General
