Cisco CRS Series - CHAPTER 3 Implementing Automatic Multicast Routing:; Automatic Multicast Tunneling

interface GigabitEthernet0/0/2/0
!
!
mpls ldp
router-id 1.1.1.1
graceful-restart
mldp
logging internal
!
<all core-facing interfaces>
!
!
multicast-routing
address-family ipv4
nsf
mdt source Loopback0
interface all enable
accounting per-prefix
!
!
router pim
vrf 101
address-family ipv4
rpf topology route-policy mldp-101
vpn-id 101
rp-address 10.1.101.1
!
!
VRF In-band Profile
vrf 250
address-family ipv4 unicast
import route-target
250:250
!
export route-target
250:250
!
!
!
interface Loopback0
ipv4 address 1.1.1.1 255.255.255.255
!
interface Loopback250
vrf 250
ipv4 address 10.1.250.1 255.255.255.255
!
route-policy mldp-250
set core-tree mldp-inband
end-policy
!
router ospf 1
address-family ipv4 unicast
area 0
mpls traffic-eng
interface Loopback0
!
interface Loopback1
!
interface GigabitEthernet0/0/2/0
!
interface GigabitEthernet0/3/2/1
!
interface GigabitEthernet0/3/2/2
!
!
mpls traffic-eng router-id Loopback0
!
router bgp 100
address-family ipv4 unicast
Cisco IOS XR Multicast Configuration Guide for the Cisco CRS Router, Release 5.2.x
183
Implementing Multicast Routing on Cisco IOS XR Software
Configuring LSM based MLDP: Examples