EasyManua.ls Logo

Cisco GoQAM - Page 56

Cisco GoQAM
178 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 3 Provision the RF GoQAM
40 4004834 Rev D
Field Description
Administrative State Specifies whether the modulator is active within the system.
The values are:
Offline: Default
Online: Active
MAC Address Displays the MAC address of the GoQAM
Subnet Mask Displays the IP subnet mask assigned by the system
administrator
Default Gateway Displays the network default gateway assigned by the
system administrator
Ports
The following table lists the Ports field descriptions.
Field Description
Reserved TSID Range Identifies the available range of Transport Stream IDs (TSIDs)
Input Block 1 ASI 1 Clear
Transport Stream ID
Identifies the Transport Stream ID for input block 1 at ASI 1
Input Block 2 ASI 3 Clear
Transport Stream ID
Identifies the Transport Stream ID for input block 2 at ASI 3
Port to Hubs Allows you to specify which hub is associated to any selected
RF output port. The default is all hubs under the defined
headend
RF Out Parameters
The following table lists the RF OUT port (1 2) field descriptions.
Note: Overlay technology uses only two of the RF OUT ports on the RF GoQAM.
Field Description
Modulation Displays the modulation format of the individual carriers
The default is 64-QAM for ITU J.83 Annex B.
Transport Stream ID Displays the identifier of the transport stream ID for each RF
Out module

Table of Contents