6 Enter the required configuration information into the blank fields on the Basic
Parameters tab in the Set Up RF GOQAM window, then go to step 9.
Important: Be sure to associate the port with a hub by clicking the Port to Hubs
button to open the RF Output Port window.
7 From the QAM List, highlight an RF GoQAM in the list, select File > Open. The
Set Up RF GOQAM window opens with the Basic Parameters tab to the forefront
displaying the Basic Parameters configuration fields.
8 Enter or change the desired information in the Basic Parameters fields.
Important: Be sure to associate the port with a hub by clicking the Port to Hubs
button to open the RF Output Port window.
Notes:
See the Basic Parameters field descriptions, earlier in this section, for
descriptions of each field.
Refer to the Digital Network Control System Online Help for your system
release for more details about required DNCS procedures.
To Next Page
Loading...