9 Click the Advanced Parameters tab. The Set Up RF GOQAM window opens
with the Advanced Parameters tab to the forefront displaying the Advanced
Parameters configuration fields.
10 Enter or change the desired information in the Advanced Parameters fields.
Notes:
See the Advanced Parameters field descriptions, earlier in this section, for
more details.
Refer to the Digital Network Control System Online Help for your system
release for more details about required DNCS procedures.
11 To define the Configuration File Name, click Select. The File Selection Dialog
window opens.
12 Enter the configuration file in the Selection field; then, click OK. The File
Selection Dialog window closes.
Note: See the File Selection Dialog tab description, earlier in this section for
more information.
13 Choose one of the following options:
To provision the connectivity settings for a new RF GoQAM, go to step 14.
To adjust the connectivity settings for an existing RF GoQAM, go to step 15.
To Next Page
Loading...