Cisco GoQAM - Page 83

Understand the Set Up UpConverter GUI
4004834 Rev D 67
11 To view or edit an RF Output Port, highlight a row and click Open. An RF
Output port similar to the following opens.
Note: For a description of the fields in the RF Output Port window, go to the RF
Output Ports section in Set Up UpConverter Basic Parameters (on page 68).
12 Did you make changes in the RF Output Port window?
 If yes, click Save.
 If no, click Cancel.
13 On the Set Up UpConverter window, click Apply. The system applies the
settings.