Field Description
Cancel Closes the window without saving changes that
have not been previously applied
Help Opens the DNCS Online Help
Understanding Set Up UpConverter Connectivity
The Connectivity fields of the Set Up UpConverter window allow you to specify the
IF GoQAM connected to each of the Input ports on the upconverter.
Note: When you first provision the upconverter, the Connectivity fields only appear
after you click Apply or Save from the Set Up UpConverter window. Thereafter, the
Connectivity fields are accessible for viewing or modifying.
To view the Connectivity fields while reading this section, click the Connectivity tab
in the Set Up UpConverter window.
The following diagram shows an example of the Connectivity fields of the Set Up
UpConverter window.
To Next Page
Loading...
General