2-78
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
OL-11469-02
Chapter 2 Messages and Recovery Procedures
CWAN_RP Messages
Error Message %CWAN_RP-3-WAN_BRIDGING_CONFIG_EXCEEDED: The number of
VPLS/EoMPLS/Bridging/QinQ VCs exceeded the maximum supported by the platform
Explanation
The user attempted to configure more VPLS, EoMPLS, and bridging VCs than the
number that is supported by the platform.
Recommended Action Review the configuration guidelines for the features that are being configured,
and reduce the number of VPLS, EoMPLS, and bridging VCs to the number that is supported by the
platform.
CWAN_RP-4
Error Message %CWAN_RP-4-CONFIG_MISMATCH: Irreconcilable Configuration difference
between Active & Standby Supervisors due to OIR/Config Event -> Reloading Standby
Supervisor to synchronize the configuration.
Explanation
An unexpected configuration difference exists between the active and standby
supervisor engines.
Recommended Action This condition is expected behavior. No action is required.
Error Message %CWAN_RP-4-LCLOG_MSG : slot [dec]/[dec]: [chars]
Explanation
An error has occurred on a module. The slot and CPU number are indicated after the
CWAN_RP-4-LCLOG_MSG text. The error message that appears after the slot number is the
original message from the module.
Recommended Action Follow any instructions provided in the error message text. If no instructions
are provided, copy the message exactly as it appears on the console or in the system log. Research
and attempt to resolve the issue using the tools and utilities provided at http://www.cisco.com/tac.
With some messages, these tools and utilities will supply clarifying information. Search for resolved
software issues using the Bug Toolkit at http://tools.cisco.com/Support/BugToolKit/. If you still
require assistance, open a case with the Technical Assistance Center via the Internet at
http://tools.cisco.com/ServiceRequestTool/create, or contact your Cisco technical support
representative and provide the representative with the information you have gathered. Attach the
following information to your case in nonzipped, plain-text (.txt) format: the output of the show
logging and show tech-support commands and your pertinent troubleshooting logs.
To Next Page
Loading...
Need help?
General