2-155
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
OL-11469-02
Chapter 2 Messages and Recovery Procedures
IXP_MAP Messages
IXP_MAP Messages
This section contains ESF Network Processor Client Mapper (IXP_MAP) messages.
IXP_MAP-3
Error Message %IXP_MAP-3-QOS_CONFIG: [chars] error detected: [chars] [chars] [hex]
[hex]
Explanation
A configuration error for the QoS ESF Network Processor Client Mapper was detected.
This configuration error is not considered fatal to the operation of the ESF Network Processors. The
software is designed to detect and report the error condition.
Recommended Action Change the configuration to correct the QoS ACL configuration problem. If the
condition persists, copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the issue using the tools and utilities provided at
http://www.cisco.com/tac. With some messages, these tools and utilities will supply clarifying
information. Search for resolved software issues using the Bug Toolkit at
http://tools.cisco.com/Support/BugToolKit/. If you still require assistance, open a case with the
Technical Assistance Center via the Internet at http://tools.cisco.com/ServiceRequestTool/create, or
contact your Cisco technical support representative and provide the representative with the
information you have gathered. Attach the following information to your case in nonzipped,
plain-text (.txt) format: the output of the show logging and show tech-support commands and your
pertinent troubleshooting logs
KEYMAN Messages
This section contains key string encryption (KEYMAN) messages.
KEYMAN-4
Error Message %KEYMAN-4-KEYSTR_BAD_CRYPTO: Bad encrypted keystring for key id [dec].
Explanation
The system could not successfully decrypt an encrypted key string. The key string may
have been corrupted during system configuration.
Recommended Action Reenter the key string command, and reconfigure the key string.
To Next Page
Loading...
Need help?
General