2-9
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
OL-11469-02
Chapter 2 Messages and Recovery Procedures
BGP Messages
messages, these tools and utilities will supply clarifying information. Search for resolved software
issues using the Bug Toolkit at http://tools.cisco.com/Support/BugToolKit/. If you still require
assistance, open a case with the Technical Assistance Center via the Internet at
http://tools.cisco.com/ServiceRequestTool/create, or contact your Cisco technical support
representative and provide the representative with the information you have gathered. Attach the
following information to your case in nonzipped, plain-text (.txt) format: the output of the show
logging and show tech-support commands and your pertinent troubleshooting logs.
ATMSPA-4
Error Message %ATMSPA-4-VCSETUP: [chars]: VC setup command received on the LC for an
existing VC (VCD [dec])
Explanation
A command to set up a VC has been received for a VC that has already been set up and
configured by a previous setup VC command from the route processor (RP). A duplicate setup
command may indicate that the RP did not receive a response from the line card for the previous
setup command.
Recommended Action No action is required.
Error Message %ATMSPA-4-VCTEARDOWN: [chars]: VC tear down command received on the LC
for a non-existing VC (VCD [dec])
Explanation
The VC does not exist on the line card. The VC may have been torn down by a previous
teardown command from the RP. A duplicate teardown command may indicate that the RP did not
receive a response from the line card for the previous teardown command.
Recommended Action No action is required.
BGP Messages
This section contains Border Gateway Protocol (BGP) messages.
BGP-3
Error Message %BGP-3-ADDPATH: Number of paths for [chars] exceeded allowed maximum
of [dec]
Explanation
BGP is receiving the same prefix from too many neighbors.
Recommended Action Restrict the number of neighbors advertising the same prefix by implementing
inbound filters.
To Next Page
Loading...
Need help?
General