2-212
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
OL-11469-02
Chapter 2 Messages and Recovery Procedures
RPC Messages
Error Message %RF-3-WAKEUP_STANDBY_NOT_SEEN: Active-Standby RP Handshake Error. The
Standby RP did not receive a WAKEUP_STANDBY message from the Active RP during the
early initialization phase on the Standby RP.
Explanation
As part of the early initialization phase, the standby route processor (RP) asks the active
RP to awaken it when the active RP is ready to support the standby RP. The active RP has failed to
awaken the standby RP. The active RP may have failed during the standby RP’s early initialization
phase or some other error has prevented the active RP from completing this handshake.
Recommended Action The standby RP will be restarted. If the problem persists, restart the system.
RF-6
Error Message %RF-6-STANDBY_READY: The Standby RP has reached HOT-STANDBY state and
is now ready for stateful switchover.
Explanation
The standby route processor (RP) has reached the hot-standby state and is now ready to
take over operation in the event that the active RP should fail.
Recommended Action No action is required.
RPC Messages
This section contains Remote Procedure Call (RPC) messages.
RPC-2
Error Message %RPC-2-FAILED: Failed to send RPC request [chars] (fatal)
Explanation
A fatal communication error occurred during an RPC request.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the issue using the tools and utilities provided at
http://www.cisco.com/tac. With some messages, these tools and utilities will supply clarifying
information. Search for resolved software issues using the Bug Toolkit at
http://tools.cisco.com/Support/BugToolKit/. If you still require assistance, open a case with the
Technical Assistance Center via the Internet at http://tools.cisco.com/ServiceRequestTool/create, or
contact your Cisco technical support representative and provide the representative with the
information you have gathered. Attach the following information to your case in nonzipped,
plain-text (.txt) format: the output of the show logging and show tech-support commands and your
pertinent troubleshooting logs.
To Next Page
Loading...
Need help?
General