Cisco III - Supervisor Engine III - Pf_Asic-1; PFINIT Messages; Pfinit-1; Pfinit-5

2-193
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
OL-11469-02
Chapter 2 Messages and Recovery Procedures
PFINIT Messages
PF_ASIC-1
Error Message %PF_ASIC-3-ASIC_DUMP: [[dec]:[hex]] [chars] = [hex]
Explanation
This message displays relevant ASIC counters that might help in diagnosing a problem
with the switching bus.
Recommended Action Copy this message and the SWITCHING_BUS_IDLE message exactly as they
appear on the console or in the system log. Contact your Cisco technical support representative with
the output. Include this output along with the SWITCHING_BUS_IDLE error message.
PFINIT Messages
This section contains platform initialization (PFINIT) messages.
PFINIT-1
Error Message %PFINIT-1-CONFIG_SYNC_FAIL: Sync’ing the [chars] configuration to the
standby Router FAILED
Explanation
The active router could not synchronize its configuration with the redundant router. This
condition might be a transient one that was caused by the configuration file being temporarily used
by another process.
Recommended Action Retry the synchronization operation.
PFINIT-5
Error Message %PFINIT-5-CONFIG_SYNC_NOT_SUPPORTED: Sync'ing the [chars]
configuration to the standby Router is not supported.
Explanation
The configuration has not been successfully synchronized with the standby router.
[chars] is the configuration name.
Recommended Action This is an informational message. No action is required.