2-209
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
OL-11469-02
Chapter 2 Messages and Recovery Procedures
R4K_MP Messages
Error Message %QM-6-EOM_TRUST_NOT_INSTALLED: ’no trust’ command is not installed on
[chars] in presence of EoMPLS
Explanation
If EoMPLS is configured on the interface or any of its subinterfaces, the no trust
command is not installed.
Recommended Action Remove all EoMPLS configurations from the interface.
R4K_MP Messages
This section contains central processing unit (R4K_MP) messages.
R4K_MP-3
Error Message %R4K_MP-3-CRASHED: CPU [dec] has now crashed a total of [dec] times.
Explanation
The specified CPU failed the specified number of times and has been restarted.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the issue using the tools and utilities provided at
http://www.cisco.com/tac. With some messages, these tools and utilities will supply clarifying
information. Search for resolved software issues using the Bug Toolkit at
http://tools.cisco.com/Support/BugToolKit/. If you still require assistance, open a case with the
Technical Assistance Center via the Internet at http://tools.cisco.com/ServiceRequestTool/create, or
contact your Cisco technical support representative and provide the representative with the
information you have gathered. Attach the following information to your case in nonzipped,
plain-text (.txt) format: the output of the show logging and show tech-support commands and your
pertinent troubleshooting logs.
R4K_MP-5
Error Message %R4K_MP-5-DELEGATE_GETBUF: Delegated call to [hex] failed, out of
buffers
Explanation
An RPC to the specified function failed.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the issue using the tools and utilities provided at
http://www.cisco.com/tac. With some messages, these tools and utilities will supply clarifying
information. Search for resolved software issues using the Bug Toolkit at
http://tools.cisco.com/Support/BugToolKit/. If you still require assistance, open a case with the
Technical Assistance Center via the Internet at http://tools.cisco.com/ServiceRequestTool/create, or
contact your Cisco technical support representative and provide the representative with the
information you have gathered. Attach the following information to your case in nonzipped,
plain-text (.txt) format: the output of the show logging and show tech-support commands and your
pertinent troubleshooting logs.
To Next Page
Loading...
Need help?
General