Cisco III - Supervisor Engine III User Manual

2-208
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
OL-11469-02
Chapter 2 Messages and Recovery Procedures
QM Messages
Error Message %QM-2-PLC_ATTACH_REJECT_SET: Command rejected: (policy [chars]
interface [chars] dir [chars]) police/trust and set commands present in same
traffic class
Explanation
This message indicates one of two conditions: either a policy map that contains a traffic
class with both set and police/trust commands is attached to an unsupported interface or a policy
attached to an interface is being modified in an unsupported manner.
Recommended Action Remove the unsupported command combination from the same traffic class. In
the case of a modification to a policy that is already attached to unsupported interfaces, no action is
required because the command is automatically rejected.
QM-4
Error Message %QM-4-AGG_POL_EXCEEDED: QoS Hardware Resources Exceeded : Out of
Aggregate policers
Explanation
Only a limited number of aggregate policers can be supported. On EARL7-based
switches, this limit is 1023.
Recommended Action Attempt to aggregate policers if possible.
Error Message %QM-4-MFLOW_POL_EXCEEDED: QoS Hardware Resources Exceeded : Out of
Micro flow policers
Explanation
Only a limited number of microflow policers can be supported. On EARL7-based
switches, this limit is 63.
Recommended Action No action is required.
QM-6
Error Message %QM-6-EOM_FORCE_TRUSTED: EoMPLS on [chars] caused install of ’trust
cos’ state
Explanation
If EoMPLS is configured on the interface or any of its subinterfaces, the “no trust” state
is automatically replaced by the “trust CoS” state.
Recommended Action Remove all EoMPLS configurations from the interface to restore the “no trust”
state.
Error Message %QM-6-EOM_RESTORE_UNTRUSTED: The ’no trust’ state is restored on
EoMPLS removal from [chars]
Explanation
If EoMPLS is unconfigured on the interface and all its subinterfaces, the “no trust” state
is restored.
Recommended Action No action is required.

Cisco III - Supervisor Engine III Specifications

General

Brand	Cisco
Model	III - Supervisor Engine III
Category	Software
Language	English