2-218
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
OL-11469-02
Chapter 2 Messages and Recovery Procedures
SCP Messages
Error Message %SBFIFO-1-RESET: MAC-FIFO Still in Reset
Explanation
The system attempted to access the MAC-FIFO while it was still being reset.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the issue using the tools and utilities provided at
http://www.cisco.com/tac. With some messages, these tools and utilities will supply clarifying
information. Search for resolved software issues using the Bug Toolkit at
http://tools.cisco.com/Support/BugToolKit/. If you still require assistance, open a case with the
Technical Assistance Center via the Internet at http://tools.cisco.com/ServiceRequestTool/create, or
contact your Cisco technical support representative and provide the representative with the
information you have gathered. Attach the following information to your case in nonzipped,
plain-text (.txt) format: the output of the show logging and show tech-support commands and your
pertinent troubleshooting logs.
SBFIFO-3
Error Message %SBFIFO-3-ERRINT: [chars], error interrupt, mac_status = [hex]
Explanation
The MAC-FIFO controller signalled an error condition.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the issue using the tools and utilities provided at
http://www.cisco.com/tac. With some messages, these tools and utilities will supply clarifying
information. Search for resolved software issues using the Bug Toolkit at
http://tools.cisco.com/Support/BugToolKit/. If you still require assistance, open a case with the
Technical Assistance Center via the Internet at http://tools.cisco.com/ServiceRequestTool/create, or
contact your Cisco technical support representative and provide the representative with the
information you have gathered. Attach the following information to your case in nonzipped,
plain-text (.txt) format: the output of the show logging and show tech-support commands and your
pertinent troubleshooting logs.
Error Message %SBFIFO-3-TOOBIG: [chars], packet too big ([dec]), from [enet]
Explanation
The interface detects a packet larger than the value that is defined by MTU.
Recommended Action Determine the MTU setting of the other station. No action is required.
SCP Messages
This section contains Switch Module Configuration Protocol (SCP) messages.
To Next Page
Loading...
Need help?
General