EasyManua.ls Logo

Cisco III - Supervisor Engine III - EOU Messages; Eou-2; Eou-4

Cisco III - Supervisor Engine III
368 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2-130
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
OL-11469-02
Chapter 2 Messages and Recovery Procedures
EOU Messages
information you have gathered. Attach the following information to your case in nonzipped,
plain-text (.txt) format: the output of the show logging and show tech-support commands and your
pertinent troubleshooting logs.
EOU Messages
This section contains Extensible Authentication Protocol over UDP (EOU) messages.
EOU-2
Error Message %EOU-2-PROCESS_ERR: Router could not create a EAPoUDP process
Explanation
The system could not create an Extensible Authentication Protocol over UDP (EOU)
process.
Recommended Action Reload the system.
EOU-4
Error Message %EOU-4-BAD_PKT: IP=[IP_address]| Bad Packet=[chars]
Explanation
The system received an invalid or malformed EAP packet from the specified host.
Recommended Action Check the specified host for the EAP operation.
Error Message %EOU-4-MSG_ERR: Unknown message event reveived
Explanation
The EOU authentication process received an unknown message event.
Recommended Action If this message recurs, reload the system.
Error Message %EOU-4-PROCESS_STOP: PROCESS=[chars]| ACTION=[chars].
Explanation
The specified process has stopped.
Recommended Action Reload the system.
Error Message %EOU-4-SOCKET: EAPoUDP socket binding fails for PORT=[hex]. Check if
the interface has valid IP address.
Explanation
The EOU socket could not bind its port to an valid interface address.
Recommended Action This condition is probably caused by a missing IP address on the interface.
Configure a valid IP address for the interface.

Table of Contents

Related product manuals