Cisco III - Supervisor Engine III - MLSM Messages; Mlsm-6

2-173
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
OL-11469-02
Chapter 2 Messages and Recovery Procedures
MLSM Messages
MLSM Messages
This section contains Multicast Distributed Shortcut Switching (MDSS)/multilayer switching for
multicast (MLSM) messages.
MLSM-6
Error Message %MLSM-6-MLSM_PMS: MMLS: MLSM is suspending the caller process [chars]
Explanation
MLSM is suspending the caller process. This message appears when the MLSM
routines are called from the PIM/Mwheel context and MLSM routines suspend a process. When
MLSM suspends the caller process, data corruption might occur for the data that is handled by the
caller process.
Recommended Action This message is informational.
Error Message %MLSM-6-MMLS_EGRESS_INFO: MMLS: Please make sure no multicast traffic
is going through egress incapable line cards when system is operating in egress
mode
Explanation
There should be no multicast traffic going through egress-incapable line cards while the
system is operating in egress replication mode.
Recommended Action Determine if there are any egress-incapable line cards in the system. If there
are egress-incapable line cards, verify that there is no multicast traffic going through them.
Error Message %MLSM-6-MMLS_LEGACY_INSERTED: MMLS: Legacy Linecard Inserted, Egress
Replication Mode will be disabled
Explanation
Egress replication is not supported with legacy modules. The system will transition to
ingress mode and will cause a temporary loss of traffic.
Recommended Action If the system is required to operate in egress replication mode, remove the
legacy module.
Error Message %MLSM-6-MMLS_MODE_CHANGE: MMLS: Replication Mode Change Detected
Explanation
When automatic detection of the replication mode is enabled, the system will transition
to ingress mode when an egress-incapable module is inserted. The system will transition back to
egress mode when the last egress-incapable module is removed.
Recommended Action Transitioning between ingress and egress mode causes a temporary loss of
traffic. To prevent this temporary loss of traffic, enter the mls ip replication-mode ingress
command.