2-84
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
OL-11469-02
Chapter 2 Messages and Recovery Procedures
CWSLC Messages
CWRPSPA-3
Error Message %CWRPSPA-3-MAX_SPA: Power to IPSEC-SPA-2G in [chars] is denied because
it has exceeded the number allowed([dec])
Explanation
The number of IPSEC-SPA-2G port adapters in a chassis is limited. This message
displays when the number of IPSEC-SPA-2G port adapters in the chassis has exceeded the limit.
Recommended Action Use only the number of supported IPSEC-SPA-2G port adapters.
CWRPSPA-4
Error Message %CWRPSPA-4-SPA_CMD_NO_RESP: [chars]: No response for interface
configuration command [int]
Explanation
A timeout occurred while the RP was waiting for a response from the line card. This
condition may occur when the line card CPU is too busy to respond to the configuration command.
Recommended Action Retry the configuration command.
CWRPSPA-6
Error Message %CWRPSPA-6-CARDRELOAD: Module [int] reload due to SPA insert in
[int]/[int].
Explanation
When inserting a SPA on the specified module, the module resets.
Recommended Action This message is informational. No action is required.
CWSLC Messages
This section contains WAN SiByte Module (CWSLC) messages.
CWSLC-3
Error Message %CWSLC-3-DIAGFAIL: Failed to handle diag [chars] [dec]
Explanation
The module failed to execute a diagnostics command.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the issue using the tools and utilities provided at
http://www.cisco.com/tac. With some messages, these tools and utilities will supply clarifying
information. Search for resolved software issues using the Bug Toolkit at
http://tools.cisco.com/Support/BugToolKit/. If you still require assistance, open a case with the
To Next Page
Loading...
Need help?
General