2-117
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
OL-11469-02
Chapter 2 Messages and Recovery Procedures
EARL_L3_ASIC Messages
EARL_L3_ASIC-4
Error Message %EARL_L3_ASIC-4-CPU_PAR_ERR: EARL L3 ASIC: CPU Parity error. Error
data [hex]. Error address [hex]
Explanation
The EARL Layer 3 ASIC detected a CPU parity error. This condition is caused by an
interprocess communication error between the CPU and the Layer 3 ASIC.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the issue using the tools and utilities provided at
http://www.cisco.com/tac. With some messages, these tools and utilities will supply clarifying
information. Search for resolved software issues using the Bug Toolkit at
http://tools.cisco.com/Support/BugToolKit/. If you still require assistance, open a case with the
Technical Assistance Center via the Internet at http://tools.cisco.com/ServiceRequestTool/create, or
contact your Cisco technical support representative and provide the representative with the
information you have gathered. Attach the following information to your case in nonzipped,
plain-text (.txt) format: the output of the show logging and show tech-support commands and your
pertinent troubleshooting logs.
Error Message %EARL_L3_ASIC-4-INTR_THROTTLE: Throttling "[chars]" interrupt
exceeded permitted [int]/[dec] interrupts/msec
Explanation
Excessive interrupts were generated by the EARL ASIC.
Recommended Action Interrupt throttling has been performed to protect the supervisor engine. If this
message recurs, copy the message exactly as it appears on the console or in the system log. Research
and attempt to resolve the issue using the tools and utilities provided at http://www.cisco.com/tac.
With some messages, these tools and utilities will supply clarifying information. Search for resolved
software issues using the Bug Toolkit at http://tools.cisco.com/Support/BugToolKit/. If you still
require assistance, open a case with the Technical Assistance Center via the Internet at
http://tools.cisco.com/ServiceRequestTool/create, or contact your Cisco technical support
representative and provide the representative with the information you have gathered. Attach the
following information to your case in nonzipped, plain-text (.txt) format: the output of the show
logging and show tech-support commands and your pertinent troubleshooting logs.
To Next Page
Loading...
Need help?
General