2-119
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
OL-11469-02
Chapter 2 Messages and Recovery Procedures
EARL_NETFLOW Messages
Error Message %EARL_NETFLOW-3-NF_ECC_SOFT_MAX: Too many Netflow ECC errors have
occurred, Total Ecc Errors [[dec]]
Explanation
The total number of NetFlow ECC errors has exceeded the soft limit number. The soft
limit of Netflow ECC errors is 2500. The hard limit is 5000. When the hard limit is reached, the line
card will reboot.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the issue using the tools and utilities provided at
http://www.cisco.com/tac. With some messages, these tools and utilities will supply clarifying
information. Search for resolved software issues using the Bug Toolkit at
http://tools.cisco.com/Support/BugToolKit/. If you still require assistance, open a case with the
Technical Assistance Center via the Internet at http://tools.cisco.com/ServiceRequestTool/create, or
contact your Cisco technical support representative and provide the representative with the
information you have gathered. Attach the following information to your case in nonzipped,
plain-text (.txt) format: the output of the show logging and show tech-support commands and your
pertinent troubleshooting logs.
EARL_NETFLOW-4
Error Message %EARL_NETFLOW-4-ICAM_THRLD: Netflow ICAM threshold exceeded, ICAM
Utilization [[dec]%]
Explanation
The NetFlow ICAM is almost full. Aggressive aging is temporarily enabled.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the issue using the tools and utilities provided at
http://www.cisco.com/tac. With some messages, these tools and utilities will supply clarifying
information. Search for resolved software issues using the Bug Toolkit at
http://tools.cisco.com/Support/BugToolKit/. If you still require assistance, open a case with the
Technical Assistance Center via the Internet at http://tools.cisco.com/ServiceRequestTool/create, or
contact your Cisco technical support representative and provide the representative with the
information you have gathered. Attach the following information to your case in nonzipped,
plain-text (.txt) format: the output of the show logging and show tech-support commands and your
pertinent troubleshooting logs.
Error Message %EARL_NETFLOW-4-NF_AGG_CACHE_THR: Netflow [chars] aggregation cache is
almost full.
Explanation
The aggregation cache for NetFlow is almost full. This condition might cause a high
CPU load.
Recommended Action Consider increasing the size of the aggregation cache, or remove the
aggregation cache configuration specified in the error message.
To Next Page
Loading...
Need help?
General