2-151
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
OL-11469-02
Chapter 2 Messages and Recovery Procedures
IPFAST Messages
Error Message %IPFAST-2-FASTPORTOPEN: Requested to open [chars], id [int] when
already open. Attempting to re-open.
Explanation
The line card is attempting to open a port to the route processor when one is already
open. This behavior could be transient but might result in multiple ports opened for the same
purpose.
Recommended Action The router should be able to recover from this situation. If CEF problems
develop for this line card, copy the error message exactly as it appears on the console or in the
system log, and contact your Cisco technical support representative.
Error Message %IPFAST-2-FASTPORTOPENERR: Attempt to open [chars] failed after [dec]
retries (last error:[chars])
Explanation
The line card attempted to open a port to the route processor but has failed after a few
retries. This condition might result in the CEF becoming disabled on the line card.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the issue using the tools and utilities provided at
http://www.cisco.com/tac. With some messages, these tools and utilities will supply clarifying
information. Search for resolved software issues using the Bug Toolkit at
http://tools.cisco.com/Support/BugToolKit/. If you still require assistance, open a case with the
Technical Assistance Center via the Internet at http://tools.cisco.com/ServiceRequestTool/create, or
contact your Cisco technical support representative and provide the representative with the
information you have gathered. Attach the following information to your case in nonzipped,
plain-text (.txt) format: the output of the show logging and show tech-support commands and your
pertinent troubleshooting logs.
Error Message %IPFAST-2-FASTPORTREGISTERERR: Attempt to register [chars] failed
after [dec] retries (last error:[chars])
Explanation
The line card attempted to register a port to the route processor but has failed after a few
retries. This condition might result in the CEF becoming disabled on the line card.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the issue using the tools and utilities provided at
http://www.cisco.com/tac. With some messages, these tools and utilities will supply clarifying
information. Search for resolved software issues using the Bug Toolkit at
http://tools.cisco.com/Support/BugToolKit/. If you still require assistance, open a case with the
Technical Assistance Center via the Internet at http://tools.cisco.com/ServiceRequestTool/create, or
contact your Cisco technical support representative and provide the representative with the
information you have gathered. Attach the following information to your case in nonzipped,
plain-text (.txt) format: the output of the show logging and show tech-support commands and your
pertinent troubleshooting logs.
To Next Page
Loading...
Need help?
General