2-175
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
OL-11469-02
Chapter 2 Messages and Recovery Procedures
MLS_RATE Messages
Error Message %MLS_RATE-4-LIMITING_DOWN: MLS HARDWARE RATE-LIMITING functionality is
not active
Explanation
There are not enough memory resources to support the rate limiting functionality.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the issue using the tools and utilities provided at
http://www.cisco.com/tac. With some messages, these tools and utilities will supply clarifying
information. Search for resolved software issues using the Bug Toolkit at
http://tools.cisco.com/Support/BugToolKit/. If you still require assistance, open a case with the
Technical Assistance Center via the Internet at http://tools.cisco.com/ServiceRequestTool/create, or
contact your Cisco technical support representative and provide the representative with the
information you have gathered. Attach the following information to your case in nonzipped,
plain-text (.txt) format: the output of the show logging and show tech-support commands and your
pertinent troubleshooting logs.
Error Message %MLS_RATE-4-NO_RESOURCE: The hardware Rate Limiters are fully used
Explanation
There are no more hardware rate limiters available.
Recommended Action EARL supports a limited number of hardware rate limiters. All may be used.
To display the features that use these hardware rate limiters, enter the show mls rate-limit usage
command. To program a rate limiter for the new feature, unconfigure one of the configured rate
limiters.
Error Message %MLS_RATE-4-NOT_SUPPORTED: This functionality is not configurable.
Explanation
The rate limit functionality is not active with the current hardware configuration.
Recommended Action Refer to the feature usage guidelines for more details.
Error Message %MLS_RATE-4-OVERWRITING_VALUE: Overwriting the rate value for: [chars]
case
Explanation
Some rate limiters share the same hardware register. This message is printed if
programming a new rate limiter causes a previously configured one to be overwritten.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the issue using the tools and utilities provided at
http://www.cisco.com/tac. With some messages, these tools and utilities will supply clarifying
information. Search for resolved software issues using the Bug Toolkit at
http://tools.cisco.com/Support/BugToolKit/. If you still require assistance, open a case with the
Technical Assistance Center via the Internet at http://tools.cisco.com/ServiceRequestTool/create, or
contact your Cisco technical support representative and provide the representative with the
information you have gathered. Attach the following information to your case in nonzipped,
plain-text (.txt) format: the output of the show logging and show tech-support commands and your
pertinent troubleshooting logs.
To Next Page
Loading...
Need help?
General