2-42
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
OL-11469-02
Chapter 2 Messages and Recovery Procedures
C7600_SSC400 Messages
Error Message %C7600_SSC400-3-DP_PROGRAMMING: [chars] FPGA failed to program.
Explanation
This field-programmable gate array (FPGA) failed to program. This condition indicates
a hardware failure, possibly due to a failed field-programmable device (FPD) upgrade.
Recommended Action Enter show hw-module slot fpd.If this message recurs, copy the error message
exactly as it appears on the console or in the system log. Research and attempt to resolve the error
using the Output Interpreter https://www.cisco.com/cgi-bin/Support/OutputInterpreter/home.pl.
Also perform a search of the Bug Toolkit http://www.cisco.com/cgi-bin/Support/Bugtool/home.pl.
If you still require assistance, open a case with the Technical Assistance Center via the Internet
http://tools.cisco.com/ServiceRequestTool/create, or contact your Cisco technical support
representative and provide the representative with the gathered information.
Error Message %C7600_SSC400-3-DPRX_ERR: [chars].
Explanation
An error occurred while receiving data from the SPA, possibly due to data corruption.
Recommended Action If this message recurs, copy the error message exactly as it appears on the
console or in the system log. Research and attempt to resolve the error using the Output Interpreter
https://www.cisco.com/cgi-bin/Support/OutputInterpreter/home.pl. Also perform a search of the
Bug Toolkit http://www.cisco.com/cgi-bin/Support/Bugtool/home.pl. If you still require assistance,
open a case with the Technical Assistance Center via the Internet
http://tools.cisco.com/ServiceRequestTool/create, or contact your Cisco technical support
representative and provide the representative with the gathered information.
Error Message %C7600_SSC400-3-DPTX_ERR: [chars].
Explanation
An error occurred while sending data to the SPA, possibly due to data corruption.
Recommended Action If this message recurs, copy the error message exactly as it appears on the
console or in the system log. Research and attempt to resolve the error using the Output Interpreter
https://www.cisco.com/cgi-bin/Support/OutputInterpreter/home.pl. Also perform a search of the
Bug Toolkit http://www.cisco.com/cgi-bin/Support/Bugtool/home.pl. If you still require assistance,
open a case with the Technical Assistance Center via the Internet
http://tools.cisco.com/ServiceRequestTool/create, or contact your Cisco technical support
representative and provide the representative with the gathered information.
Error Message %C7600_SSC400-3-DPTX_QDR: Error clearing QDR queue [dec].
Explanation
A quad data rate (QDR) queue did not flush completely.
Recommended Action If this message recurs, copy the error message exactly as it appears on the
console or in the system log. Research and attempt to resolve the error using the Output Interpreter
https://www.cisco.com/cgi-bin/Support/OutputInterpreter/home.pl. Also perform a search of the
Bug Toolkit http://www.cisco.com/cgi-bin/Support/Bugtool/home.pl. If you still require assistance,
open a case with the Technical Assistance Center via the Internet
http://tools.cisco.com/ServiceRequestTool/create, or contact your Cisco technical support
representative and provide the representative with the gathered information.
To Next Page
Loading...
Need help?
General