2-61
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
OL-11469-02
Chapter 2 Messages and Recovery Procedures
CONST_DIAG Messages
Error Message %CONST_DIAG-3-HM_ALL_PORT_ERR: All ports on module [dec] failed
[chars].
Explanation
The data paths that correspond to all ports of the module have failed.
Recommended Action Check your network configuration for spanning tree loops, excessive flooding,
and other related conditions. Reset the line card to see if the problem resolves itself. If the conditions
persists, copy the message exactly as it appears on the console or in the system log. Research and
attempt to resolve the issue using the tools and utilities provided at http://www.cisco.com/tac. With
some messages, these tools and utilities will supply clarifying information. Search for resolved
software issues using the Bug Toolkit at http://tools.cisco.com/Support/BugToolKit/. If you still
require assistance, open a case with the Technical Assistance Center via the Internet at
http://tools.cisco.com/ServiceRequestTool/create, or contact your Cisco technical support
representative and provide the representative with the information you have gathered. Attach the
following information to your case in nonzipped, plain-text (.txt) format: the output of the show
logging and show tech-support commands and your pertinent troubleshooting logs.
Error Message %CONST_DIAG-3-HM_CHAN_ERR: All ports in channel [dec] on module [dec]
failed [chars]. Disabled the channel.
Explanation
The data path that corresponds to the channel has failed. All ports that are part of the
channel are put into errdisable state.
Recommended Action Check your network configuration for spanning tree loops, excessive flooding,
and other related conditions. Reset the line card to see if the problem resolves itself. If the condition
persists, copy the message exactly as it appears on the console or in the system log. Research and
attempt to resolve the issue using the tools and utilities provided at http://www.cisco.com/tac. With
some messages, these tools and utilities will supply clarifying information. Search for resolved
software issues using the Bug Toolkit at http://tools.cisco.com/Support/BugToolKit/. If you still
require assistance, open a case with the Technical Assistance Center via the Internet at
http://tools.cisco.com/ServiceRequestTool/create, or contact your Cisco technical support
representative and provide the representative with the information you have gathered. Attach the
following information to your case in nonzipped, plain-text (.txt) format: the output of the show
logging and show tech-support commands and your pertinent troubleshooting logs.
Error Message %CONST_DIAG-3-HM_FCI_0_STUCK: Flow control stuck at 0 error on module
[dec]!
Explanation
The signal LDBUS_FCI_L0 is stuck on active-low. The line card is powered down.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the issue using the tools and utilities provided at
http://www.cisco.com/tac. With some messages, these tools and utilities will supply clarifying
information. Search for resolved software issues using the Bug Toolkit at
http://tools.cisco.com/Support/BugToolKit/. If you still require assistance, open a case with the
Technical Assistance Center via the Internet at http://tools.cisco.com/ServiceRequestTool/create, or
contact your Cisco technical support representative and provide the representative with the
information you have gathered. Attach the following information to your case in nonzipped,
plain-text (.txt) format: the output of the show logging and show tech-support commands and your
pertinent troubleshooting logs.
To Next Page
Loading...
Need help?
General