Log Into the Firepower Management Center
Use the FMC to configure and monitor the FTD.
Before you begin
For information on supported browsers, refer to the release notes for the version you are using (see
https://www.cisco.com/go/firepower-notes).
Procedure
Step 1 Using a supported browser, enter the following URL.
https://fmc_ip_address
Step 2 Enter your username and password.
Step 3 Click Log In.
Obtain Licenses for the Firepower Management Center
All licenses are supplied to the FTD by the FMC. You can purchase the following licenses:
• Threat—Security Intelligence and Cisco Firepower Next-Generation IPS
• Malware—Advanced Malware Protection for Networks (AMP)
• URL—URL Filtering
• RA VPN—AnyConnect Plus, AnyConnect Apex, or AnyConnect VPN Only
Before you begin
• Have a master account on the Cisco Smart Software Manager.
If you do not yet have an account, click the link to set up a new account. The Smart Software Manager
lets you create a master account for your organization.
• Your Cisco Smart Software Licensing account must qualify for the Strong Encryption (3DES/AES)
license to use some features (enabled using the export-compliance flag).
Procedure
Step 1 Make sure your Smart Licensing account contains the available licenses you need.
When you bought your device from Cisco or a reseller, your licenses should have been linked to your Smart
Software License account. However, if you need to add licenses yourself, use the Find Products and Solutions
search field on the Cisco Commerce Workspace. Search for the following license PIDs:
Cisco Firepower 1010 Getting Started Guide
99
Firepower Threat Defense Deployment with FMC
Log Into the Firepower Management Center
To Next Page
Loading...
Need help?
General