firepower(local-mgmt)# shutdown
This command will shutdown the system. Continue?
Please enter 'YES' or 'NO': yes
INIT: Stopping Cisco Threat Defense......ok
Step 3 Monitor the system prompts as the firewall shuts down.
Step 4 Observe the Power LED and Status LED to verify that the chassis is powered off (appear unlit).
Step 5 After the chassis has successfully powered off, you can then unplug the power to physically remove power
from the chassis if necessary.
What's Next?
To continue configuring your FTD, see the documents available for your software version at Navigating the
Cisco Firepower Documentation.
For information related to using FDM, see Cisco Firepower Threat Defense Configuration Guide for Firepower
Device Manager.
Cisco Firepower 1010 Getting Started Guide
85
Firepower Threat Defense Deployment with FDM
What's Next?
To Next Page
Loading...
Need help?
General