Deploy the Configuration
Deploy the configuration changes to the FTD; none of your changes are active on the device until you deploy
them.
Procedure
Step 1 Click Deploy in the upper right.
Step 2 Select the device in the Deploy Policies dialog box, then click Deploy.
Step 3 Ensure that the deployment succeeds. Click the icon to the right of the Deploy button in the menu bar to see
status for deployments.
Access the FTD and FXOS CLI
Use the command-line interface (CLI) to set up the system and do basic system troubleshooting. You cannot
configure policies through a CLI session. You can access the CLI by connecting to the console port.
You can also access the FXOS CLI for troubleshooting purposes.
Cisco Firepower 1010 Getting Started Guide
118
Firepower Threat Defense Deployment with FMC
Deploy the Configuration
To Next Page
Loading...
Need help?
General