CHAPTER 4
Firepower Threat Defense Deployment with FDM
Is This Chapter for You?
This chapter explains how to complete the initial set up and configuration of your Firepower Threat Defense
(FTD) device using the Firepower Device Manager (FDM) web-based device setup wizard.
FDM lets you configure the basic features of the software that are most commonly used for small networks.
It is especially designed for networks that include a single device or just a few, where you do not want to use
a high-powered multiple-device manager to control a large network containing many FDM devices.
If you are managing large numbers of devices, or if you want to use the more complex features and
configurations that FTD allows, use the Firepower Management Center (FMC) instead.
The Firepower 1010 hardware can run either FTD software or ASA software. Switching between FTD and
ASA requires you to reimage the device. See Reimage the Cisco ASA or Firepower Threat Defense Device.
Note
The Firepower 1010 runs an underlying operating system called the Firepower eXtensible Operating System
(FXOS). The Firepower 1010 does not support the FXOS Firepower Chassis Manager; only a limited CLI is
supported for troubleshooting purposes. See the FXOS troubleshooting guide for more information.
Privacy Collection Statement—The Firepower 1010 Series does not require or actively collect
personally-identifiable information. However, you can use personally-identifiable information in the
configuration, for example for usernames. In this case, an administrator might be able to see this information
when working with the configuration or when using SNMP.
• End-to-End Procedure, on page 62
• Review the Network Deployment and Default Configuration, on page 63
• Cable the Device, on page 66
• Power On the Device, on page 67
• (Optional) Change Management Network Settings at the CLI, on page 68
• Log Into FDM, on page 70
• Complete the Initial Configuration, on page 70
• Configure Licensing, on page 72
• Configure the Device in Firepower Device Manager, on page 78
• Access the FTD and FXOS CLI, on page 81
• View Hardware Information, on page 83
• Power Off the Firewall, on page 84
• What's Next?, on page 85
Cisco Firepower 1010 Getting Started Guide
61
To Next Page
Loading...
Need help?
General