Cisco LightStream 1010 User Manual

Central administrator: Log Into the Firepower Management Center, on page
99.
Firepower
Management Center
Obtain Licenses for the Firepower Management Center, on page 134: Buy feature
licenses.
Cisco Commerce
Workspace
Obtain Licenses for the Firepower Management Center, on page 134: Generate
a license token for the FMC.
Smart Software
Manager
Obtain Licenses for the Firepower Management Center, on page 134: Register
the FMC with the Smart Licensing server.
Firepower
Management Center
Register the FTD with the FMC, on page 135.Firepower
Management Center
Configure a Basic Security Policy, on page 102.Firepower
Management Center
Central Administrator Pre-Configuration Using the CLI
Connect to the FTD CLI to perform initial setup. When you use the CLI for initial configuration, only the
Management and FMC access interface settings are retained.
Before you begin
Deploy and perform initial configuration of the FMC. See the FMC getting started guide. You will need to
know the FMC IP address or hostname before you set up the FTD.
Procedure
Step 1 Power on the device.
Step 2 Connect to the FTD CLI, either from the console port or using SSH to the Management interface, which
obtains an IP address from a DHCP server by default. Because this procedure requires you to change the
Management interface network settings, we recommend using the console port so you do not get disconnected.
The console port connects to the FXOS CLI. The SSH session connects directly to the FTD CLI.
Step 3 Log in with the username admin and the password Admin123.
At the console port, you connect to the FXOS CLI. The first time you log in to FXOS, you are prompted to
change the password. This password is also used for the FTD login for SSH.
If the password was already changed, and you do not know it, then you must reimage the device to
reset the password to the default. See the FXOS troubleshooting guide for the reimage procedure.
Note
Example:
firepower login: admin
Password: Admin123
Successful login attempts for user 'admin' : 1
Cisco Firepower 1010 Getting Started Guide
127
Firepower Threat Defense Deployment with a Remote FMC
Central Administrator Pre-Configuration Using the CLI
All manuals and user guides at all-guides.com

Cisco LightStream 1010 Specifications

General

Brand	Cisco
Model	LightStream 1010
Category	Switch
Language	English