Cisco LightStream 1010 - Before You Start; End-To-End Procedure

• Log Into the Firepower Management Center, on page 99
• Obtain Licenses for the Firepower Management Center, on page 99
• Register the FTD with the FMC, on page 100
• Configure a Basic Security Policy, on page 102
• Access the FTD and FXOS CLI, on page 118
• Power Off the Device, on page 120
• What's Next?, on page 121
Before You Start
Deploy and perform initial configuration of the FMC. See the FMC getting started guide.
End-to-End Procedure
See the following tasks to deploy the FTD with FMC on your chassis.
Cisco Firepower 1010 Getting Started Guide
88
Firepower Threat Defense Deployment with FMC
Before You Start
All manuals and user guides at all-guides.com