---------- --------------- ----------------- ----------- -----------
1 FPR-1010 Cisco Systems, In JMX1943408S 0.3
Power Off the Firewall
It's important that you shut down your system properly. Simply unplugging the power can cause serious file
system damage. Remember that there are many processes running in the background all the time, and unplugging
or shutting off the power does not allow the graceful shutdown of your Firepower system.
The Firepower 1010 chassis does not have an external power switch.You can power off the firewall using
FDM, or you can use the FXOS CLI.
Power Off the Firewall Using FDM
You can shut down your system properly using FDM.
Procedure
Step 1 Use FDM to shut down the firewall.
For 6.4 and earlier, enter the shutdown command at the FDM CLI.
Note
a) Click Device, then click the System Settings > Reboot/Shutdown link.
b) Click Shut Down.
Step 2 Observe the Power LED and Status LED to verify that the chassis is powered off (appear unlit).
Step 3 After the chassis has successfully powered off, you can then unplug the power to physically remove power
from the chassis if necessary.
Power Off the Device at the CLI
You can use the FXOS CLI to safely shut down the system and power off the device. You access the CLI by
connecting to the console port; see Access the FTD and FXOS CLI, on page 81.
Procedure
Step 1 In the FXOS CLI, connect to local-mgmt:
firepower # connect local-mgmt
Step 2 Issue the shutdown command:
firepower(local-mgmt) # shutdown
Example:
Cisco Firepower 1010 Getting Started Guide
84
Firepower Threat Defense Deployment with FDM
Power Off the Firewall
To Next Page
Loading...
Need help?
General