firepower # connect local-mgmt
Step 2 Issue the shutdown command:
firepower(local-mgmt) # shutdown
Example:
firepower(local-mgmt)# shutdown
This command will shutdown the system. Continue?
Please enter 'YES' or 'NO': yes
INIT: Stopping Cisco Threat Defense......ok
Step 3 Monitor the system prompts as the firewall shuts down.
Step 4 Observe the Power LED and Status LED to verify that the chassis is powered off (appear unlit).
Step 5 After the chassis has successfully powered off, you can then unplug the power to physically remove power
from the chassis if necessary.
What's Next?
To continue configuring your FTD, see the documents available for your software version at Navigating the
Cisco Firepower Documentation.
For information related to using FMC, see the Firepower Management Center Configuration Guide.
Cisco Firepower 1010 Getting Started Guide
121
Firepower Threat Defense Deployment with FMC
What's Next?
To Next Page
Loading...
Need help?
General