Step 3 Check the Status LED on the back or top of the device; after it is solid green, the system has passed power-on
diagnostics.
(Optional) Change the IP Address
If you cannot use the default IP address for ASDM access, you can set the IP address of the management
interface at the ASA CLI.
This procedure restores the default configuration and also sets your chosen IP address, so if you made any
changes to the ASA configuration that you want to preserve, do not use this procedure.
Note
Procedure
Step 1 Connect to the ASA console port, and enter global configuration mode. See Access the ASA and FXOS CLI,
on page 177 for more information.
Step 2 Restore the default configuration with your chosen IP address.
configure factory-default [ip_address [mask]]
Example:
ciscoasa(config)# configure factory-default 10.1.1.151 255.255.255.0
Based on the management IP address and mask, the DHCP address
pool size is reduced to 103 from the platform limit 256
WARNING: The boot system configuration will be cleared.
The first image found in disk0:/ will be used to boot the
system on the next reload.
Verify there is a valid image on disk0:/ or the system will
not boot.
Begin to apply factory-default configuration:
Clear all configuration
Executing command: interface management1/1
Executing command: nameif management
INFO: Security level for "management" set to 0 by default.
Executing command: ip address 10.1.1.151 255.255.255.0
Executing command: security-level 100
Executing command: no shutdown
Executing command: exit
Executing command: http server enable
Executing command: http 10.1.1.0 255.255.255.0 management
Executing command: dhcpd address 10.1.1.152-10.1.1.254 management
Executing command: dhcpd enable management
Executing command: logging asdm informational
Factory-default configuration is completed
ciscoasa(config)#
Step 3 Save the default configuration to flash memory.
Cisco Firepower 1010 Getting Started Guide
169
ASA Deployment with ASDM
(Optional) Change the IP Address
To Next Page
Loading...
Need help?
General