> exit
firepower#
Power Off the Device
It's important that you shut down your system properly. Simply unplugging the power can cause serious file
system damage. Remember that there are many processes running in the background all the time, and unplugging
or shutting off the power does not allow the graceful shutdown of your Firepower system.
The Firepower 1010 chassis does not have an external power switch.You can power off the device using the
FMC device management page, or you can use the FXOS CLI.
Power Off the Device Using FMC
It's important that you shut down your system properly. Simply unplugging the power or pressing the power
switch can cause serious file system damage. Remember that there are many processes running in the
background all the time, and unplugging or shutting off the power does not allow the graceful shutdown of
your Firepower system.
You can shut down your system properly using FMC.
Procedure
Step 1 Choose Devices > Device Management.
Step 2 Next to the device that you want to restart, click the edit icon ( ).
Step 3 Click the Device tab.
Step 4 Click the shut down device icon ( ) in the System section.
Step 5 When prompted, confirm that you want to shut down the device.
Step 6 Observe the Power LED and Status LED to verify that the chassis is powered off (appear unlit).
Step 7 After the chassis has successfully powered off, you can then unplug the power to physically remove power
from the chassis if necessary.
Power Off the Device at the CLI
You can use the FXOS CLI to safely shut down the system and power off the device. You access the CLI by
connecting to the console port; see Access the FTD and FXOS CLI, on page 118.
Procedure
Step 1 In the FXOS CLI, connect to local-mgmt:
Cisco Firepower 1010 Getting Started Guide
120
Firepower Threat Defense Deployment with FMC
Power Off the Device
To Next Page
Need help?
General