SSH to the Management interface from a remote network unless you add a static route for the Management
interface using the configure network static-routes command.
The following figure shows the FMC at central headquarters and the FTD with FMC access on the outside
interface.
Either the FTD or FMC needs a public IP address or hostname to allow to allow the inbound management
connection; you need to know this IP address for initial setup. You can also optionally configure Dynamic
DNS (DDNS) for the outside interface to accommodate changing DHCP IP assignments.
Before You Start
Deploy and perform initial configuration of the FMC. See the FMC getting started guide.
Cisco Firepower 1010 Getting Started Guide
125
Firepower Threat Defense Deployment with a Remote FMC
Before You Start
To Next Page
Loading...
Need help?
General