Procedure
Step 1 Make sure your Smart Licensing account contains the available licenses you need.
When you bought your device from Cisco or a reseller, your licenses should have been linked to your Smart
Software License account. However, if you need to add licenses yourself, use the Find Products and Solutions
search field on the Cisco Commerce Workspace. Search for the following license PIDs:
Figure 44: License Search
If a PID is not found, you can add the PID manually to your order.
Note
• Threat, Malware, and URL license combination:
• L-FPR1010T-TMC=
When you add one of the above PIDs to your order, you can then choose a term-based subscription
corresponding with one of the following PIDs:
• L-FPR1010T-TMC-1Y
• L-FPR1010T-TMC-3Y
• L-FPR1010T-TMC-5Y
• RA VPN—See the Cisco AnyConnect Ordering Guide.
Step 2 If you have not already done so, register the FMC with the Smart Software Manager.
Registering requires you to generate a registration token in the Smart Software Manager. See the FMC
configuration guide for detailed instructions.
Register the FTD with the FMC
Register the FTD to the FMC.
Before you begin
• Gather the following information that you set in the FTD initial configuration:
• FTD management IP address or hostname, and NAT ID
• FMC registration key
Cisco Firepower 1010 Getting Started Guide
135
Firepower Threat Defense Deployment with a Remote FMC
Register the FTD with the FMC
To Next Page
Loading...
