Cisco LightStream 1010 User Manual

Link : Up
Channels : Management & Events
Mode : Non-Autonegotiation
MDI/MDIX : Auto/MDIX
MTU : 1500
MAC Address : 28:6F:7F:D3:CB:8D
----------------------[ IPv4 ]----------------------
Configuration : Manual
Address : 10.99.10.4
Netmask : 255.255.255.0
Gateway : 10.99.10.1
----------------------[ IPv6 ]----------------------
Configuration : Disabled
===============[ Proxy Information ]================
State : Disabled
Authentication : Disabled
======[ System Information - Data Interfaces ]======
DNS Servers :
Interfaces : GigabitEthernet1/1
===============[ GigabitEthernet1/1 ]===============
State : Enabled
Link : Up
Name : outside
MTU : 1500
MAC Address : 28:6F:7F:D3:CB:8F
----------------------[ IPv4 ]----------------------
Configuration : Manual
Address : 10.89.5.29
Netmask : 255.255.255.192
Gateway : 10.89.5.1
----------------------[ IPv6 ]----------------------
Configuration : Disabled
Check that the FTD registered with the FMC
At the FTD CLI, check that the FMC registration was completed. Note that this command will not show
the current status of the management connection.
show managers
> show managers
Type : Manager
Host : 10.89.5.35
Registration : Completed
>
Ping the FMC
At the FTD CLI, use the following command to ping the FMC from the data interfaces:
ping fmc_ip
At the FTD CLI, use the following command to ping the FMC from the Management interface, which
should route over the backplane to the data interfaces:
ping system fmc_ip
Cisco Firepower 1010 Getting Started Guide
153
Firepower Threat Defense Deployment with a Remote FMC
Troubleshoot Management Connectivity on a Data Interface
All manuals and user guides at all-guides.com

Cisco LightStream 1010 Specifications

General

Brand	Cisco
Model	LightStream 1010
Category	Switch
Language	English