Figure 5: Cisco SSO Dashboard
Step 6 Click the authenticator logo to choose Duo Security or Google Authenticator, if you have set up both
authenticators.
• If you already have a user record on an existing tenant, you are logged into that tenant.
• If you already have a user record on several tenants, you will be able to choose which CDO tenant to
connect to.
• If you do not already have a user record on an existing tenant, you will be able to learn more about CDO
or request a trial account.
Onboard the Device Using Low-Touch Provisioning and the Serial Number
To onboard a Firepower device to CDO using LTP, you complete this procedure, connect the device to a
network that can reach the internet, and power on the device.
Before you begin
Low-touch provisioning (LTP) is a feature that allows a new factory-shipped Firepower 1010 series device
to be provisioned and configured automatically, eliminating many of the manual tasks involved with onboarding
the device to CDO.
Your device needs to have Version 6.7 or greater installed to use LTP. If you want to use this method to
onboard an FTD device running on an older software version (6.4, 6.5, and 6.6), you need to perform a fresh
installation of the software on that device, not an upgrade.
Note
Procedure
Step 1 In the navigation pane, click Devices & Services and click the blue plus button to Onboard a device.
Step 2 Click on the FTD card.
Cisco Firepower 1010 Getting Started Guide
15
Firepower Threat Defense Deployment with CDO and Low-Touch Provisioning
Onboard the Device Using Low-Touch Provisioning and the Serial Number
To Next Page
Loading...
Need help?
General