Figure 47: View Token
Figure 48: Copy Token
Step 3 In ASDM, choose Configuration > Device Management > Licensing > Smart Licensing.
Step 4 Click Register.
Step 5 Enter the registration token in the ID Token field.
You can optionally check the Force registration check box to register an ASA that is already registered, but
that might be out of sync with the License Authority. For example, use Force registration if the ASA was
accidentally removed from the Smart Software Manager.
Step 6 Click Register.
The ASA registers with the License Authority using the pre-configured outside interface, and requests
authorization for the configured license entitlements. The License Authority also applies the Strong Encryption
(3DES/AES) license if your account allows. ASDM refreshes the page when the license status is updated.
You can also choose Monitoring > Properties > Smart License to check the license status, particularly if
the registration fails.
Step 7 Set the following parameters:
a) Check Enable Smart license configuration.
Cisco Firepower 1010 Getting Started Guide
174
ASA Deployment with ASDM
Configure Licensing
To Next Page
Loading...
Need help?
General