Step 7 Choose Refresh Licenses to synchronize license information with Cisco Smart Software Manager.
Configure the Device in CDO
The following steps provide an overview of additional features you might want to configure. Please click the
help button (?) on a page to get detailed information about each step.
Procedure
Step 1 Log in to the CDO portal, choose Devices & Services from the CDO menu, and then select the device you
just onboarded.
Step 2 Choose Management > Interfaces and select the physical interface you want to configure.
Step 3 Click the edit icon ( ) for each interface you want to configure and give the interface a Logical Name and,
optionally, a Description.
Unless you configure subinterfaces, the interface should have a name.
If you change the name, the change is automatically reflected everywhere you used the old name,
including security zones, syslog server objects, and DHCP server definitions. However, you cannot
remove the name until you first remove all configurations that use the name, because you typically
cannot use an unnamed interface for any policy or setting.
Note
Step 4 Set the Type and define the IP address and other settings.
The following example configures an interface to be used as a “demilitarized zone” (DMZ), where you place
publicly-accessible assets such as your web server. Click Save when you are finished.
Cisco Firepower 1010 Getting Started Guide
53
Firepower Threat Defense Deployment with CDO
Configure the Device in CDO
To Next Page
Loading...
Need help?
General