You can also review the DNS settings supplied to clients on the DNS Server tab. The following example
shows how to set up a DHCP server on the inside2 interface with the address pool
192.168.45.46-192.168.45.254.
Figure 24: DHCP Server
Step 7 Choose Management > Routing, then click the Add icon to configure a default route.
The default route normally points to the upstream or ISP router that resides off the outside interface. A default
IPv4 route is for any-ipv4 (0.0.0.0/0), whereas a default IPv6 route is for any-ipv6 (::0/0). Create routes for
each IP version you use. If you use DHCP to obtain an address for the outside interface, you might already
have the default routes that you need.
The routes you define on this page are for the data interfaces only. They do not impact the
management interface. Set the management gateway on Management > Settings > Management
Access.
Note
The following example shows a default route for IPv4. In this example, isp-gateway is a network object that
identifies the IP address of the ISP gateway (you must obtain the address from your ISP). You can create this
object by clicking Create New Object at the bottom of the Gateway drop-down list.
Cisco Firepower 1010 Getting Started Guide
55
Firepower Threat Defense Deployment with CDO
Configure the Device in CDO
To Next Page
Loading...
Need help?
General