Power Off the Firewall Using FDM
You can shut down your system properly using FDM.
Procedure
Step 1 Use FDM to shut down the firewall.
For 6.4 and earlier, enter the shutdown command at the FDM CLI.
Note
a) Click Device, then click the System Settings > Reboot/Shutdown link.
b) Click Shut Down.
Step 2 Observe the Power LED and Status LED to verify that the chassis is powered off (appear unlit).
Step 3 After the chassis has successfully powered off, you can then unplug the power to physically remove power
from the chassis if necessary.
What's Next
To continue configuring your FTD using CDO, see the CDO Configuration Guides.
For additional information related to using CDO, see the Cisco Defense Orchestrator home page.
Cisco Firepower 1010 Getting Started Guide
59
Firepower Threat Defense Deployment with CDO
Power Off the Firewall Using FDM
To Next Page
Loading...
