2-107
Cisco ME 3400 Ethernet Access Switch Command Reference
OL-9640-10
Chapter 2 Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands
errdisable detect cause
If you set a recovery mechanism for the cause by entering the errdisable recovery global configuration
command for the cause, the interface is brought out of the error-disabled state and allowed to retry the
operation when all causes have timed out. If you do not set a recovery mechanism, you must enter the
shutdown and then the no shutdown commands to manually recover an interface from the
error-disabled state.
Examples This example shows how to enable error-disabled detection for the link-flap error-disabled cause:
Switch(config)# errdisable detect cause link-flap
You can verify your setting by entering the show errdisable detect privileged EXEC command.
Related Commands Command Description
show errdisable detect Displays errdisable detection information.
show interfaces status err-disabled Displays interface status or a list of interfaces in the
error-disabled state.
To Next Page
Loading...
