Cisco ME 3400 - Debug Ip Sla Trace Twamp Connection

B-20
Cisco ME 3400 Ethernet Access Switch Command Reference
OL-9640-10
Appendix B Cisco ME 3400 Ethernet Access Switch Debug Commands
debug ip sla trace twamp connection
debug ip sla trace twamp connection
Use the debug ip sla trace twamp connection command in privileged EXEC mode to display the
normal communications between a Cisco IOS IP Service Level Agreements (SLAs) Two-Way Active
Measurement Protocol (TWAMP) client and server. Use the no form of this command to disable
debugging output.
debug ip sla trace twamp connection [source-ip ip-address]
no debug ip sla trace twamp connection [source-ip ip-address]
Syntax Description
Command Modes Privileged EXEC
Command History
Usage Guidelines The debug ip sla trace twamp connection privileged EXEC command displays messages about normal
communications between the client and server during a TWAMP session.
Note Use the debug ip sla error twamp connection command before using the debug ip sla trace twamp
connection command because the debug ip sla error twamp connection command generates less
debugging output.
The debug ip sla trace twamp connection command is supported in IPv4 networks.
The undebug ip sla trace twamp connection command is the same as the no debug ip sla trace twamp
connection command.
Related Commands
source-ip
ip-address
(Optional) Debug IP Performance Metrics (IPPM) TWAMP connections for
the specified source. Specify the source using the client device IP address.
Release Modification
12.2(52)SE This command was introduced.
Command Description
debug ip sla error twamp
connection
Displays exceptions during communication between the IP SLAs
TWAMP client and server.
debug ip sla error twamp
control reflector
Displays exceptions during communication between the IP SLAs
TWAMP server and reflector.
debug ip sla error twamp
control server
Displays exceptions during communication between the IP SLAs
TWAMP server and reflector.
debug ip sla error twamp
session
Displays exceptions during communication between the IP SLAs
TWAMP sender and reflector.
debug ip sla trace twamp
control reflector
Displays the normal communications sent by an IP SLAs TWAMP
reflector to the TWAMP server.